Skip to content
Austin Air Conditioning Solutions Call(469) 771-1630

Refrigerant Leak Repair in Austin, TX

We locate refrigerant leaks at coils, valves, and line sets across Austin.

An air conditioning technician kneeling at an outdoor condenser unit beside a stone house, a manifold gauge set connected to its service valves

Most people first turn the thermostat down and check the return filter when the vents feel warm. That’s a sensible first move, because a blocked filter or incorrect setting can cut airflow. We can check those items, but neither one replaces refrigerant that has escaped from the sealed line set.

With a leak, the system can keep running while the evaporator coil gets too cold and collects ice. We trace the loss rather than adding refrigerant alone, since a recharge only masks an opening at a coil, service valve, or joint. This isn’t work to put off, because low refrigerant can freeze the coil and leave the compressor working harder.

Warm air and ice

Warm air at the supply vents is a common reason people call us, especially when one bedroom never cools. We also hear about ice on the copper line, a hissing sound near the outdoor unit, and an indoor coil that drips after the system stops. Some systems run for long stretches without reaching the thermostat setting, while others shut down after the coil freezes.

Those symptoms can overlap, but we don’t treat them as one fault. A loose service-valve core, a damaged line-set joint, and a leaking evaporator coil call for different repairs and parts. We need to locate the actual escape point before we can tell you what applies to your unit.

Leak inspection callout

At a leak inspection callout, we read the model plate, inspect the copper line set, and look over the evaporator and condenser coils. We connect gauges to record operating pressures, then use an electronic detector and, where needed, a pressure test to trace the refrigerant path. With clear access to the equipment, that testing commonly takes thirty to sixty minutes, though a hidden coil can take longer.

We can often replace an accessible service-valve core or repair a reachable connection during the same visit. We recover refrigerant before opening the circuit, then evacuate the repaired system and charge it to the manufacturer specification. If the leak is in a coil or a concealed line set, we’ll explain the repair and arrange a return visit once the needed part is available.

Coil access and valve age

The age of the coil and the route to it matter. An outdoor condenser with removable panels is different from an evaporator coil above a finished ceiling or inside a tight attic. We also look at corrosion around the copper tubing and whether a service valve will open without damage.

Cost changes when the leak sits at an accessible valve rather than inside a coil, and when a standard core is enough rather than a coil or line-set section. A part that has to be ordered adds another visit, while restricted attic access or a seized valve adds labor at the unit. We’ll show you where the leak is and explain the repair path before work moves forward.

Model plate and indoor unit

Have the model and serial number from the outdoor condenser’s data plate ready when you call. We can use that plate to match the refrigerant type and check parts that fit your equipment.

We also need to know which room holds the indoor air handler, whether the system is still running, and whether an attic hatch, gate, or panel blocks access. If you can see ice on the copper line or water below the indoor unit, tell us where it appears. Call Austin Air Conditioning Solutions at (469) 771-1630; a continuing leak can freeze the evaporator coil and put extra load on the compressor.

When we are open

  • Monday Open 24 hours
  • Tuesday Open 24 hours
  • Wednesday Open 24 hours
  • Thursday Open 24 hours
  • Friday Open 24 hours
  • Saturday Open 24 hours
  • Sunday Open 24 hours

Next

Next: ac drain line cleaning, or back to the home page.