Skip to content
Austin Air Conditioning Solutions Call(469) 771-1630

AC Drain Line Cleaning in Austin, TX

We clear clogged AC drain lines before water reaches the pan or cabinet.

A technician standing with arms folded beside an outdoor condenser unit at the side of a house, a mown lawn running away behind her

When water shows up by the indoor unit, people tell us, "My AC is leaking," or, "There’s a puddle under the closet unit." They may also mention a sour smell from a ceiling vent or a system that shuts off after running.

Those reports can point to condensate backing up in the drain pan, a blocked trap, or a float switch stopping the unit. We clean the drain route after checking where the water starts and where it should leave. We handle these calls at homes in Austin, Rollingwood, West Lake Hills, and Lost Creek. That line carries water away while the evaporator coil removes humidity from indoor air. A backed-up drain line shouldn’t wait, because water in the pan can overflow into the air-handler cabinet, ceiling, or wall.

Puddle by the unit

A puddle beside the indoor cabinet, water staining a ceiling below it, or water coming from a secondary pan are different calls. You might hear gurgling at the drain pipe when the blower runs, especially after the system has been cooling.

Some people report a musty smell from a supply vent, while others say the AC stops and the thermostat still has power. A clogged drain can cause those signs, but a cracked pan, blocked trap, failed condensate pump, or float switch can look similar.

We have to inspect the pipe, pan, and switch before we know which fault is present. Those faults need different parts and labor, so they don’t carry the same charge.

Drain-line callout

We start at the indoor air handler and trace the drain to its termination. We check the pan, trap, float switch, drain opening, and pipe size, which is often 3/4-inch PVC on residential equipment.

Then we test flow with water and clear loose sludge or algae using a wet vacuum or drain-cleaning tool. A basic inspection and flush commonly takes 30 to 60 minutes when the line and access are clear.

We can often clear a reachable clog, rinse the trap, and test the float switch during that visit. If testing shows a failed float switch or pump, we identify the matching replacement part before installation. A cracked pan, concealed pipe, failed pump, or replacement part that must be ordered may need another appointment.

Drain route and float switch

An exposed PVC outlet and a drain trap beside the air handler take less investigation than a pipe buried above a finished ceiling. A clog at the outlet is different from water held in a pan or a line that runs through a wall.

The age and condition of the float switch, condensate pump, pan, and PVC joints also matter. If a switch has failed, a pan is cracked, or a pump or fitting must be ordered, the work extends beyond cleaning.

If the unit is in a condo or mechanical closet with restricted access, we may need property approval before opening a shared drain route.

Model plate and drain outlet

Before you call, find the model number on the data plate inside or on the side of the indoor air-handler cabinet. Tell us which room holds that cabinet and whether water is under the unit, in a pan, or on the ceiling below.

If you can see the drain outlet, let us know whether water is coming from it while the AC runs. Mention whether the closet, attic hatch, or ceiling panel gives clear access to the drain pipe. You can reach us at (469) 771-1630; a full drain pan can spill farther into the cabinet or ceiling when cleaning waits.

When we are open

  • Monday Open 24 hours
  • Tuesday Open 24 hours
  • Wednesday Open 24 hours
  • Thursday Open 24 hours
  • Friday Open 24 hours
  • Saturday Open 24 hours
  • Sunday Open 24 hours

Next

Next: condenser coil cleaning, or back to the home page.