Air Conditioner Repair in Austin, TX
We diagnose warm air, noises, and AC failures across Austin and nearby areas.
Warm air from the vents or a loud hum at the outdoor unit is hard to ignore. A burning smell near the air handler needs attention before the system runs again. When the thermostat is set correctly but the room temperature rises, the cooling equipment is not doing its job. A damp patch near the indoor unit can also point to a fault that needs checking.
We trace faults in central AC equipment throughout Austin, Rollingwood, West Lake Hills, and Lost Creek. Most air conditioner faults should not be left running, because a struggling fan, capacitor, or compressor can damage other parts. If you smell burning insulation or see smoke near the disconnect box, turn the system off at the thermostat and breaker.
Warm air and condenser humming
You may hear a repeated click from the condenser without the fan starting. The indoor blower may run while the vents blow room-temperature air. Some systems start for a few minutes, shut off, and then try again. Others make a grinding sound from the outdoor cabinet or freeze around the refrigerant line.
A weak capacitor, worn contactor, blocked airflow, failing fan motor, and compressor problem can feel similar from inside the house. We need to inspect the unit because those faults use different parts and lead to different repair costs.
Condenser and air handler callout
During a callout, we check the thermostat setting, air filter, breaker, disconnect box, indoor blower, and outdoor condenser. We inspect wiring terminals for heat damage and test the capacitor, contactor, fan motor, and compressor operation. We also let the equipment run long enough to compare return-air and supply-air temperatures. A stable temperature reading usually takes about 10 to 15 minutes of operation.
We measure electrical readings against the equipment label and check refrigerant pressures against the manufacturer's specifications. A failed capacitor, fuse, contactor, or accessible fan motor can often be replaced during the same visit when the part is available. A compressor, evaporator coil, or model-specific control board may need to be ordered and scheduled for another visit.
Compressor access and control boards
The age and condition of the failed part affect the work involved. A standard capacitor in an open condenser compartment is different from a control board inside an older air handler. If the model uses a discontinued board or a matched motor, the correct part may need to be ordered before replacement.
Access also matters. An attic air handler behind tight framing, a condenser behind a locked gate, or a corroded disconnect can add labor before testing or replacement begins. Equipment that needs a permit or inspection sign-off can also involve steps beyond the repair itself.
Model plate and unit location
Before you call, look for the model and serial number on the metal plate of the outdoor condenser or indoor air handler. Tell us which room is not cooling and whether the indoor blower, outdoor fan, or both are running.
If you know the approximate age of the system, that can help narrow down likely parts. Let us know about attic access, gates, pets, or furniture near the air handler. You can reach Austin Air Conditioning Solutions at (469) 771-1630. A unit that keeps trying to start can overheat the compressor or damage electrical wiring if it keeps running.
When we are open
- Monday Open 24 hours
- Tuesday Open 24 hours
- Wednesday Open 24 hours
- Thursday Open 24 hours
- Friday Open 24 hours
- Saturday Open 24 hours
- Sunday Open 24 hours
Next
Next: thermostat repair, or back to the home page.
